How to build
Tent kit LED holder
How to build the new tent LED holder guide.
This is the new model of 3d printable tent LED holder.
All parts from this guide can be used with the SuperGreenLab construction set.
Click to change
Attach your SGL LED panels to your tent poles.
Perfect led holders for tent setups.
Those holders can be clipped to any 16mm tent poles.
Could be e
All the parts used for the SGL kits.
SuperGreenLab's construction set.
If you own a 3d printer these are all the parts used to cre
Push the transparent holder part into the arm's wrist.
Then add a 16mm screw to secure the holder in place.
Now attach the arm to the wrist, use a square nut on one side to screw everything together.
Now add a the pole clip to the arm.
And that's it, you have to do it 6 times now:)
You will notice that you have two different types, with two longer arms.
Usually the idea is that you will have the longer ones to hold the highest panels.
You can now clip all your holders as you wish.
Don't forget that it's better to spread your light power on a large surface, and from different angles!
Once the holder is glued to your furniture you can tighten the screws.
Don't over tighten is tho, just enough for it to stay in place.
The kit is shipped with 16mm (5/8") clips, some tents might have larger poles. Let me know if it's your case.